Inline on a Linux router

The routed set up presumes the set of clients are on distinct networks behind a single physical interface. For the purposes of this example will we presume

  • The clients are on network 172.28.56.0/24
  • The router connects the networks 172.28.56.0/24 and 192.168.1.0/24
  • Interface eth0 is on the network 192.168.1.0/24
  • Interface eth1 is on the network 172.28.56.0/24
  • The router is already configured to route traffic correctly for the clients.

In this example we will intercept port 80 (HTTP) traffic that traverses the router. The first step is to use iptables to handle IP packets appropriately.

# reflow client web traffic to TPROXY
iptables -t mangle -A PREROUTING -i eth1 -p tcp -m tcp --dport 80 -j TPROXY \
   --on-ip 0.0.0.0 --on-port 8080 --tproxy-mark 1/1
# Let locally directed traffic pass through.
iptables -t mangle -A PREROUTING -i eth0 --source 192.168.1.0/24 -j ACCEPT
iptables -t mangle -A PREROUTING -i eth0 --destination 192.168.1.0/24 -j ACCEPT
# Mark presumed return web traffic
iptables -t mangle -A PREROUTING -i eth0 -p tcp -m tcp --sport 80 -j MARK --set-mark 1/1

We mark packets so that we can use policy routing on them. For inbound packets we use TPROXY to make it possible to accept packets sent to foreign IP addresses. For returning outbound packets there will be a socket open bound to the foreign address, we need only force it to be delivered locally. The value for --on-ip is 0 because the target port is listening and not bound to a specific address. The value for --on-port must match the Traffic Server server port. Otherwise its value is arbitrary. --dport and --sport specify the port from the point of view of the clients and origin servers. The middle two lines exempt local web traffic from being marked for Traffic Server – these rules can be tightened or loosened as needed. They server by matching traffic and exiting the iptables processing via ACCEPT before the last line is checked.

Once the flows are marked we can force them to be delivered locally via the loopback interface via a policy routing table.

ip rule add fwmark 1/1 table 1
ip route add local 0.0.0.0/0 dev lo table 1

The marking used is arbitrary but it must be consistent between iptables and the routing rule. The table number must be in the range 1..253.

To configure Traffic Server set the following values in records.config

proxy.config.http.server_ports
STRING Default: value from --on-port
proxy.config.reverse_proxy.enabled
INT Default: 1
proxy.config.url_remap.remap_required
INT Default: 0